Terms and conditions of use
Welcome to our website. If you continue to browse and use this website, you are agreeing to comply with and be bound by the following terms and conditions of use, which together with our privacy policy govern RM Racing Electronics’ relationship with you in relation to this website. If you disagree with any part of these terms and conditions, please do not use our website.
The term ‘RM Racing Electronics, ‘low-cost racing solutions’ or ‘us’ or ‘we’ refers to the owner of the website. The term ‘you’ refers to the user or viewer of our website.
The use of this website is subject to the following terms of use:
- The content of the pages of this website is for your general information and use only. It is subject to change without notice.
- This website uses cookies to monitor browsing preferences. If you do allow cookies to be used, the following personal information may be stored by us for use by third parties, please consult our privacy policy.
- Neither we nor any third parties provide any warranty or guarantee as to the accuracy, timeliness, performance, completeness or suitability of the information and materials found or offered on this website for any particular purpose. You acknowledge that such information and materials may contain inaccuracies or errors and we expressly exclude liability for any such inaccuracies or errors to the fullest extent permitted by law.
- Your use of any information or materials on this website is entirely at your own risk, for which we shall not be liable. It shall be your own responsibility to ensure that any products, services or information available through this website meet your specific requirements.
- This website contains material which is owned by or licensed to us. This material includes, but is not limited to, the design, layout, look, appearance and graphics. Reproduction is prohibited other than in accordance with the copyright notice, which forms part of these terms and conditions.
- All trademarks reproduced in this website that are not the property of, or licensed to, the operator are acknowledged on the website.
- Unauthorized use of this website may give rise to a claim for damages and/or be a criminal offence.
- From time to time this website may also include links to other websites. These links are provided for your convenience to provide further information. They do not signify that we endorse the website(s). We have no responsibility for the content of the linked website(s).
- Your use of this website and any dispute arising out of such use of the website is subject to the laws of USA, England, Northern Ireland, Scotland and Wales.
- Products for sale on this website are for off-road and motorsport use only, we will not be responsible for any damage or accident caused by the road use of these products and we will not be liable for any damage caused to your vehicle or other vehicles that might result from the installation of any of the products sold on this website. The description term ”plug and play” and ”plug in” are used to describe Standalone ecu’s that plug directly into the main wiring harness of the car/model described on the product title and/or description and don’t need any further wiring modifications on the wiring loom of the vehicle unless described on the product description or advised to the customer directly by any means of communication, ECU’s sold with the description of the terms above will still require configuration and tuning unless advised/informed on the product description or directly to the customer.
- Limitation of Liability No responsibility whatsoever is accepted by RM Racing Electronics (www.rmracingelectronics.com) for the fitment of these Products. The onus is clearly on the installer to ensure that both their knowledge and the parts selected are correct for that particular application. Any damage to parts or consequential damage or costs resulting from the incorrect installation of these products are totally the responsibility of the installer.
- RM Racing Electronics will not be liable for any direct, indirect, incidental, consequential, or special damages, including but not limited to, damage, injury, loss of life, loss of property or equipment, loss of profits or revenue, or claims from any individual or entity arising from the use of any RM Racing Electronics product.
- ALTERING AN ENGINE CONTROL SYSTEM SETUP IS A DANGEROUS ACTIVITY AND PURCHASERS OF RM Racing Electronics PRODUCTS ACKNOWLEDGE THE INHERENT RISKS ASSOCIATED. RM Racing Electronics MAKES NO REPRESENTATIONS THAT ITS PRODUCTS CAN REDUCE OR ELIMINATE ANY SUCH RISK. RM Racing Electronics products are NOT FOR ROAD, HIGHWAY, MARINE, OR AIRCRAFT USE and are intended ONLY for Dyno testing or vehicles operated on private land and/or according to the laws of your country, with appropriate supervision of qualified technicians or mechanics to ensure that the safety needs of the driver and others are met. RM Racing Electronics products could be combined with other products or parts which may not be suitable and could adversely affect the performance of other engine management parts or the vehicle. The user shall determine the ultimate suitability and safety of the product for its intended use, and the user assumes all responsibility and risk in connection therewith.
- Emissions regulations, EPA, CARB, Disclaimer: Use of Standalone ECUs in Motorsports, Off-Road, and Racing Vehicles Only USA & CA
- This information is provided for general informational purposes only and should not be construed as legal advice. Users are advised to consult with legal professionals for guidance specific to their situation.
- The use of standalone Engine Control Units (ECUs) on road vehicles is subject to regulations imposed by the Environmental Protection Agency (EPA) and the California Air Resources Board (CARB). It is the responsibility of the vehicle owner/installer to ensure compliance with all applicable federal and state regulations.
- EPA regulations may govern the modification of emission control systems on motor vehicles, and CARB regulations may apply to vehicles in California. Failure to comply with these regulations may result in legal consequences, including fines and penalties.
- Users are urged to thoroughly research and understand EPA and CARB regulations before installing standalone ECUs on road vehicles. Additionally, it is recommended to seek professional advice to ensure compliance with all relevant laws.
- Our products are intended for use in motorsports, off-road, and racing vehicles only as explained in ”Limitation of Liability”. An off-road or racing-only vehicle is typically defined as a vehicle not designed for use on public roads and used exclusively for off-road, closed-course, or track activities. Such vehicles may include but are not limited to, off-road racing cars, drag racing cars, and dedicated track vehicles.
- We do not accept any liability for the improper use of our products in non-motorsports, non-off-road, and non-racing vehicles. The user assumes all responsibility for any consequences resulting from the use of standalone ECUs outside the intended application.
- The information provided here does not constitute legal advice, and the user assumes all responsibility for any consequences resulting from the use of standalone ECUs in motorsports, off-road, and racing vehicles.
- Shipments and return your shipment Delivery is generally free for the customer, most products are shipped next day according to the delivery method selected by the customer. Custom-made products as PNP standalone ecu’s normally take 10-15 working days to be ready to ship to a maximum of 30 days depending on the difficulty of the project or number of orders as we do all ecu’s in a ”first come first served” order. RM Racing Electronics is an international brand and company, as of 2023 most orders will be shipped from our USA office rather than our UK office, please consult your country’s customs entity to understand more about importation and taxes, or send us an email and we will help you.
- Some countries might charge you customs and handling fees, we have no control over this and the customs rates vary from country to country, before importing a product please consult the customs policy for your country.
- Customs and importation fees are the sole responsibility of the buyer, RM Racing Electronics doesn’t have any control over the payment of customs and importation fees, RM Racing Electronics doesn’t charge buyers on behalf of Customs, and returns and cancelations will not be accepted for this reasons.
- On the eventuality of a parcel being sent back due to lack of payment of customs and importation fees, the buyer will be charged for a new delivery and in case of a refund, the delivery costs will not be covered.
- Returns We will not accept any returns for custom-made products as PNP standalone ecu’s, or any other electric/electronic component and/or sensor where damage can happen by incorrect usage or installation, if you think this is probably not the best solution for you if you have any doubt’s or you need any help, please ask before you buy we can give you help in every single product we sell and point you the right way.Returns will only be accepted in standard products and the customer will be responsible for the returning costs, a refund will be sent after delivery of the product, please always send returns with tracked and signed delivery. Refunds can only be processed through the original payment method, card payments are subject to a 5-10 working days period to clear and bank transfer refunds are 2-5 days for national payments and 5-15 working days for international transfers.
Warranty
We offer 1-year warranty in most of our products, the warranty will only be given to products with case not open/violated and without any modifications unless this was authorized by us and modifications are done under our instructions, this is valid for all standalone ecu’s, we don’t sell our ecu’s as a DIY kit if you want to purchase an ecu for learning/testing purposes please inform us prior to sale.We understand that marks of use are normal as those will not be considered in terms of the warranty.